Bug-o-systems UNI-BUG III Manuel d'utilisateur Page 9
- Page / 44
- Table des matières
- DEPANNAGE
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
9
CONTROLS, CONT’D.
LCD DISPLAY: Displays the programming parameters such as travel speed, skip
length, crater ll, and weld length.
TRAVEL SPEED: Used to adjust the travel speed of the machine.
INCREASE BUTTON: Increases the numerical value of the selected parameter.
DECREASE BUTTON: Decreases the numerical value of the selected parameter.
ENTER BUTTON: Enters the set value into memory and toggles you to the next parameter.
SKIP LENGTH: When selected enter the value of the length of the skip distance.
CRATER FILL: When selected enter the value of the crater ll time.
WELD LENGTH: When selected enter the value of the length of the weld.
TRAVEL DIRECTION: Dictates which direction the machine will travel. Must be in the “OFF”
position to program parameters.
SKIP / CONTINUOUS: Used to select either the skip or continuous welding operation.
CIRCUIT BREAKER: Provides overload protection for the machine.
POWER ON / OFF: Turns power on and off to the machine.
WELD CONTACT I: If using one welding gun, switch weld contact 1 to the “ON” position.
WELD CONTACT II: If using two welding guns, both weld contact 1 and 2 should be switched
to the “ON” position.
- UNI-BUG III 1
- HIGH FREQUENCY WARNINGS 3
- INTRODUCTION 5
- SETUP DIAGRAM 6
- OPERATION 7
- CONTROLS 8
- CONTROLS, CONT’D 9
- TECHNICAL DATA / UNI-BUG III 10
- DIMENSIONS 10
- * 120 VAC Part Number 14
- ** 240 VAC Part Number 14
- *** 42 VAC Part Number 14
- UNI-2500, 2502, 2504 15
- UNI-2600, 2602, 2604 16
- UNI-2700, 2702, 2704 17
- UNI-2800-4, 2802-4, 2804-4 18
- UNI-2800-6, 2802-6, 2804-6 19
- UNI-2900, 2902, 2904 20
- 4 2 PAN-1033 Rod Clamp 39
- TROUBLESHOOTING GUIDE 42
- WARRANTY 44
- Limited 3-Year Warranty 44
Produits connexes et manuels pour Équipement Bug-o-systems UNI-BUG III
(20 pages)ASCOM No manuales de usuario
Empezando en O
Commentaires sur ces manuels