Bug-o-systems Modular Drive System Manuel d'utilisateur télécharger pdf (Page 30)

SETUP AND ALIGNMENT

Attach the rail parallel to the weld joint, with magnet bars or vacuum cups. Position the drive carriage on the

rail - see Modular Drive instructions if necessary.

Insert the welding gun into the clamp on the pendulum weaver. Adjust the racks and clamps to align the

welding gun tip with the weld joint, and tighten rmly in place.

IMPORTANT!

When the welding gun is clamped in place with the nozzle pointing into the weld groove, the centerline of

the wire must pass through the axis of the gearbox output shaft, as shown in Figure A, which is a view look-

ing along the shaft. Figure B shows the side view of the same.

For a llet weld, the nozzle will be at a 45

angle as shown in Figure C, and will swing equally in both directions.

CAUTION: The Speed Control Card in the Pendulum

Weaver is NOT interchangeable with the speed

card in the Master Drive or Linear Weaver.

Figure B

Figure A

Figure C

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 56 57

Pas de commentaire

Bug-o-systems Modular Drive System Manuel d'utilisateur Page 30